Filter
Top Products
14
ENGLISH
ENG
4.3 Safety Warnings Specific for Polishing:
Loose parts on the polishing guard, especially
the fastening cords, are not permitted. Tuck
away or shorten the fastening cords.
Loose,
spinning fastening cords may make contact with
your fingers or become caught in the workpiece.
4.4 Additional Safety Instructions
Use elastic cushioning layers if they have been
supplied with the abrasive and if required.
Observe the specifications of the tool or accessory
manufacturer! Protect the discs from grease or
impacts!
Accessories must be stored and handled with care
in accordance with the manufacturer's instruc-
tions.
The workpiece must lay flat and be secured
against slipping, e.g. using clamps. Large work-
pieces must be sufficiently supported.
For your own protection and for the
protection of your power tool, pay
attention to all parts of the text that are
marked with this symbol!
Always wear protective goggles.
Use of a fixed extractor system is recommended.
Dust from materials such as lead-containing paint
and metal may be harmful to health. Contact with
or inhalation of the dust may cause allergic reac-
tions and/or respiratory diseases to the operator or
bystanders.
Certain kinds of dust are classified as carcino-
genic. Material containing asbestos must only be
treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
Materials that generate dusts or vapours that may
be harmful to health (e.g. asbestos) must not be
processed.
When working in dusty conditions, ensure that
ventilation openings are not blocked. If it becomes
necessary to remove dust, first remove the battery
pack (use non-metallic objects) and avoid
damaging internal components.
Damaged, eccentric or vibrating tools must not be
used.
Remove the battery pack from the machine before
any adjustments, conversions or servicing are
performed.
Before fitting the battery pack, make sure that the
machine is switched off.
A damaged or cracked additional handle must be
replaced. Never operate a machine with a defec-
tive additional handle.
A damaged or cracked hand guard must be
replaced. Never operate a machine with a defec-
tive hand guard.
4.5 Safety instructions for battery packs:
Protect battery packs from water and
moisture!
Do not expose battery packs to naked
flame!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks
out and comes into contact with your eyes, wash
them with clean water and seek medical attention
immediately.
See page 3.
1 Hand protection
2 Extension arm
3 Screw for adjusting the extension arm
4 Additional handle / Additional handle with
vibration damping *
5Sliding
on/off switch
6 Electronic signal indicator
7B
attery pack release button
8 Capacity indicator button
9 Capacity and signal indicator
10 Battery pack
11 Dust filter
12 Adjusting nut
13 Accessory *
14 Support flange
15 Spindle
16 Screws for securing the hand guard
17 Allen key
18 2-hole spanner
* depending on equipment/not in scope of delivery
5Overview
17027055_0411 KNS 18 LTX 150.book Seite 14 Dienstag, 26. April 2011 2:46 14