Filter
Top Products
,
Disconnect the ironer from the
electricity supply by switching off at
the wall socket and withdrawing the
plug before any cleaning and
maintenance work.
Cleaning the heater plate
Limescale deposits and starch residues
can be removed from the heater plate
using a suitable proprietary cleaning
agent. Make sure that the ironer is cold
before cleaning it. It will be easier to
clean if you pull up the emergency
release catch.
Do not use any abrasive cleaning
agents.
Cleaning the casing
Depending on how dirty it is, the casing
can be wiped down with a dry or a
damp cloth.
Do not use any abrasive cleaning
agents.
Cleaning the water reservoir
Limescale deposits in the water
reservoir, caused by hard water, can
cause the steam jets to become
blocked. Should this happen, the
limescale deposits can be removed by
rinsing out the water reservoir with fresh
tap water.
^
Disconnect the appliance from the
electricity supply by switching off at
the socket and withdrawing the plug.
,
Allow the ironer to cool down
before rinsing out the reservoir.
Depending on the hardness level of
your water supply, the reservoir will
need to be rinsed out with tap water
after every 3 to 10 fills of the reservoir.
Stubborn limescale deposits can be
removed with a proprietary descaling
agent.
Make sure that you follow the
manufacturer's instructions on
dosage, concentration and how long
it should be used for.
^
Fill the water reservoir approximately
half full (0.4 litres) with a solution of
descaling agent and replace the cap.
^
Roll the ironer backwards and
forwards several times.
^
To prevent the risk of damaging
laundry when next ironing with steam,
the resevoir should be rinsed out
twice with fresh tap water after
descaling it.
For instructions on filling and emptying
the reservoir see "Steam".
Maintenance and care
28