Filter
Top Products
OM-230 032 Page 15
4-3. Duty Cycle And Overheating
Duty Cycle is percentage of 10
minutes that unit can weld at rated
load without overheating.
If unit overheats, thermostat(s)
opens, output stops, and cooling
fan runs. Wait fifteen minutes for
unit to cool. Reduce amperage or
duty cycle before welding.
NOTICE − Exceeding duty cycle
can damage unit and void warranty.
Overheating
0
15
A/V
OR
Reduce Duty Cycle
Minutes
duty1 4/95 − 230 226-A
Continuous Welding
100% Duty Cycle At 225 Amperes 60% Duty Cycle At 300 Amperes
6 Minutes Welding 4 Minutes Resting
4-4. Volt-Ampere Curves
va_curve1 4/95
Volt-ampere curves show minimum
and maximum voltage and
amperage output capabilities of
unit. Curves of other settings fall
between curves shown.
. This volt-ampere curve
represents the dynamic output
of the unit with a static load.
CV MODE
0
10
20
30
40
50
60
70
80
0 100 200 300 400 500 600
AMPERAGE
VOLTAGE