Miller Electric Big Blue 502D Welding System User Manual


 
OM-495 Page 10
Return To Table Of Contents
3/96
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Do not smoke and keep
matches and flames away from
battery.
3 Sparks can cause battery
gases to explode. Battery
explosion can blind and injure.
Wear a face shield.
4 Battery acid can burn skin. Do
not spill acid.
5 Read Owner’s Manual.
6 Wear rubber gloves.
7 Dead battery
8 Engine block
9 Fully charged battery
10 Do not connect last negative
cable to dead battery connect
instead to engine block.
11 Jumper cables observe
polarity and make connections
in numbered sequence shown.
12 Once dead battery is charged,
disconnect cables in sequence
shown.
1
S-176 108
+
+
1
4
2
3
+
+
+
4
1
3
2
2 3 4 5 6
10
11
7
89 12
S-176 106
3/96
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Moving parts, such as fans,
rotors, and belts, can cut
fingers and hands and cause
injury. Keep away from moving
parts.
1
2
Starting Aid Switch. Below 32°F (0°C),
push switch up for 60 seconds before
starting engine.
Starting Instructions:
1 Press and hold Magnetic
Shutdown switch.
2 Turn Engine Control switch to
Start position.
3 Release Engine Control switch
and Starting Aid switch (if used)
when engine starts.
4 Continue holding Magnetic
Shutdown switch for 3 seconds
after engine starts.