Filter
Top Products
ENGLISH
OM-1603 Page 5
3-3. Connecting Torch
A. Connecting Torch When Using A Freestanding Coolant System
Y Turn Off welding power source and
cooling system power before in-
stalling torch.
1 Welding Power Source
2 Regulator/Flowmeter
3 Gas Cylinder
4 Gas Hose (Customer Supplied)
Obtain correct length with 5/8-18 right-hand
fittings.
5 Torch
6 Power Cable Adapter
7 Coolant Hose (Customer Supplied)
Obtain correct length with 5/8-18 left-hand
fittings.
8 Coolant-Out Of Torch/Power Cable
(Red)
Connect coolant-out of torch/power cable
to power cable adapter, and connect adapt-
er to weld output terminal.
9 Torch Gas Hose
10 Coolant-Into Torch Hose (Blue)
11 Cooling System
12 Work Clamp
Connect work clamp to a clean, paint-free
location on workpiece, close to weld.
Use wire brush or sandpaper to clean metal
at weld joint area.
802 560
If applicable, install high-frequency unit.
Tools Needed:
5/8, 7/8, 1-1/8 in
5
11
1
7
2
3
4
6
9
10
8
12