Filter
Top Products
. A complete Parts List is available at www.MillerWelds.com
OM-201 872 Page 18
SECTION 5 − OPERATION
5-1. Controls
1 Gas/Air Pressure Gauge
2 Gas/Air Pressure Control
3 Output Control
Use control to select cutting output in am-
peres. Gas/air automatically flows at the set
pressure.
Use Gas/Air Set area of control range for set-
ting gas/air pressure (see Section 5-2).
4 Trouble Lights (see Section 7-2)
5 Power Light
6 Cut/Gouge Switch
Set pressure as indicated on nameplate for
appropriate switch position.
After the cutting arc goes out, the torch
will automatically re-ignite the pilot arc if
the trigger is held down.
7 Power Switch
201 853-A
7
1
2
6
4
5
3