Filter
Top Products
OM-2229 Page 11
SECTION 4 − INSTALLATION
4-1. Specifications
If the unit is operated from a 30* ampere, 115 volt circuit or a 15** ampere, 230 volt
circuit, a different input power plug must be installed on the power cord. See
Section 4-9 for instructions.
NOTE
*A 30 ampere branch circuit is recommended for maximum performance. Performance on a 20 ampere branch service may be limited due to the circuit
breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.
**A 15 ampere branch circuit is recommended for maximum performance. Performance on a 10 ampere branch service may be limited due to the circuit
breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.
A. Non-CE Model
Amperes Input at
Rated Output,
60 Hz, Single-Phase
Plasma
Rated
Cutting
Rated Output
115 V
(+15%)
230 V
(+15%)
115 V
KVA/KW
230 V
KVA/KW
Plasma
Gas
Plasma
Gas Flow/
Pressure
Cutting
Capacity
at 10 IPM
Max
OCV
27 A at 92 Volts DC At
35% Duty Cycle
28 max;
0.30*
14 max;
0.13*
3.32 KVA
3.25 KW
3.25 KVA
3.19 KW
Air Or
Nitrogen
Only
4.5 CFM
(129 L/min)
At 60 PSI
(414 kPa)
3/8 in
(10 mm)
288 Volts
DC
*While idling
B. CE Model
Amperes Input at
Rated Output,
50 Hz, Single-Phase
Plasma
Rated
Cutting
Rated Output
115 V
(+15%)
230 V
(+15%)
115 V
KVA/KW
230 V
KVA/KW
Plasma
Gas
Plasma
Gas Flow/
Pressure
Cutting
Capacity
at 10 IPM
Max
OCV
27 A at 92 Volts DC At
35% Duty Cycle
27 max;
0.33*
13 max;
0.17*
3.11 KVA
3.09 KW
3.04 KVA
3.04 KW
Air Or
Nitrogen
Only
4.5 CFM
(129 L/min)
At 60 PSI
(414 kPa)
3/8 in
(10 mm)
288 Volts
DC
*While idling
4-2. Specifications For Torch
Air-cooled torch for plasma arc cutting (PAC)
35% duty cycle
Safety interlock devices shut down power source
Safety trigger guard
Cutting capacity: see Section 4-1