Filter
Top Products
3
Tongs and Tips
(Must be ordered separately from spot welders. One pair of tips are supplied with each set of tongs.)
STANDARD 90°
No. 1 Morse Taper
No. 2 Morse Taper
#040 218
—
#040 219
—
#040 220
#041 001
6 in
(150 mm)
12 in
(304 mm)
18 in
(457 mm)
TONG LENGTH
TONGS
6-1/4 in
(159 mm)
4-1/4 in
(108 mm)
7-1/2 in
(190 mm)
9 in
(229 mm)
X
#040 223
#040 308
STANDARD 45°
No. 1 Morse Taper
No. 2 Morse Taper
—
—
#041 004
—
#041 005
#040 296
#040 851
#040 225
TT-6W
No. 2 Morse Taper
TT-9W
No. 2 Morse Taper
— — #041 838 #040 308
— — #041 840 #040 308
TIPS INCLUDED
4-1/4 in
(108 mm)
6-1/4 in
(159 mm)
X
Notes for tongs and tips:
Tongs and tips shown to the
left can be used with all PSW
and SSW model spot welders.
Recommended max. tong
length is 18 in (457 mm).
Tong throat-height dimen sion
for standard 90° and 45° tongs
is 4-1/4 in (108 mm). Throat
length is measured from the
center of the spot tips to the
front water hose connection.
X = tong length.
One set of tips is supplied with
each set of tongs.
Tips are made of RWMA Class
2 alloy.
Maximum welding capabilities
are obtained with minimum
tong length.
MT= Morse Taper.
No. 1 Morse Taper has smaller
diameter than No. 2 Morse
Taper.
#040 227
#040 223
No. 1 MT (Pointed)
#040 224
No. 1 MT (Offset)
#040 851
No. 1 MT (Offset)
#040 226
No. 1 MT (Offset)
#040 298
No. 1 MT (Offset)
#040 308
No. 2 MT (Pointed)
#040 225
No. 2 MT (Offset)
#040 216
No. 1 MT (Flat Swivel Tip)
Matching Pointed Tip
Adapter (adapts No. 1 Morse Taper Tip
to No. 2 receptacle)
2 tips
2 tips
2 tips
2 adapters
2 tips
2 tips
2 tips
2 tips
2 tips
QUANTITY
TIPS
Standard No. 1 Tongs, 90°
Standard No. 1 Tongs, 90°
Standard No. 1 Tongs, 45°
Standard No. 2 Tongs, 45°
Standard No. 1 Tongs, 90°
Standard No. 1 Tongs, 90°
Standard No. 1 Tongs, 90°
Standard No. 2 Tongs, 90°
TT-6W Tongs
TT-9W Tongs
Standard No. 2 Tongs, 90°
TT-6W Tongs (top)
TT-9W Tongs (top)
WHERE USED