Filter
Top Products
page 5
TOOL ASSEMBLY
Adjusting the Side Handle Position (Fig. 2)
1. Loosen the clamping screw slightly.
2. Pull the side handle forward and turn it to the required angle.
3. Fit the side handle into the nonslip mounting until it adjusts into place
and retighten the clamping screw securely.
NOTE: The side handle can be locked in increments of 30 degrees.
Setting the Depth Gauge (Fig. 3)
Fig. 3
Drilling depth
1. Loosen the clamping screw.
2. Slide the depth gauge rod backward or forward until it is set
for the desired depth.
NOTE: The drilling depth is the distance between the tip of the bit and
the tip of the depth gauge rod.
3. Tighten the clamping screw securely.
Installing Drill Bits and Chisels (Fig. 1)
NOTE: Only use accessories with SDS shanks.
Be sure that the shank of the bit is clean. Dirt particles may cause the bit
to line up improperly. Do not use bits larger than the maximum recom-
mended capacity of the drill because gear damage or motor overloading
may result. For best performance, be sure that the bit is properly sharp-
ened and the shank is lightly greased before use.
1. Insert the bit or chisel into the nose of the tool.
2. Rotate bit slowly until it aligns with the locking mechanism.
3. Push bit into tool until it locks.
4. Check that the bit is locked properly; it should be possible to pull the
bit back and forth slightly (about 1/4").
5. To remove bits and chisels, pull bit holder release collar toward the
rear of tool and remove bit.
NOTE: Use caution when handling hot bits and chisels.
SDS
Fig. 1
Bit holder release collar
Fig. 2
Side handle
Clamping screw
To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
WARNING!
To reduce the risk of injury, always use a side
handle when using this tool. Always brace and
hold securely.
WARNING!