Filter
Top Products
page 7
TOOL ASSEMBLY
To reduce the risk of injury, always unplug tool before
attaching or removing accessories or making adjustments.
Use only specifically recommended accessories. Others
may be hazardous.
WARNING!
1. Assemble the feed handles and grips to the hub. Tighten securely.
2. To mount the hub to either side, align the two (2) dowel pins on the
hub with the holes in the pinion. Tighten the handle screw.
Stop Knob (Fig. 2)
The stop knob is designed to stop the slide from moving.
To install, screw stop knob into location shown (Fig. 2).
Attaching Feed Handles and Grips (Fig. 1)
Adjusting the Gib Assembly (Fig. 3)
Fig. 1
Fig. 3
To adjust the gib, loosen or tighten the gib adjustment set screws on the
side of the support housing accordingly with the 3/32" hex key provided.
Tightening the set screws increases friction on the slide. The gib should
be set tight enough to support the weight of the drill in any position. All
adjusting screws should be set to provide smooth and even travel over
the entire length of slide movement.
The set screws contain a nylon patch that prevents them from moving
freely. Additional adjustment of the gib may be required from time to time
with extended use of the tool.
Adjusting the Support Bracket and Spacer for Depth of Cut
(Figs. 4 & 5)
This unit is shipped from the factory set for 1" depth cutters (Fig. 4).
When using 2" depth cutters, install support bracket with spacer on
bottom, as shown in Fig. 5.
Fig. 4
Fig. 5
Fig. 2
Stop
knob
Support bracket
Support bracket
Spacer
Spacer
NOTE: Do not use a spacer and support bracket with chuck adapter.