Filter
Top Products
4 5
OPERATION
To turn on the work light, slide the switch
to ON.
To turn off the work light, slide the switch
to OFF.
Fig. 3
ON
OFF
Switch
Clip-Lok
TM
System
The Clip-Lok system consists of two pieces;
the belt clip and the tool holder.
Fig. 4
Attaching the Belt Clip
The belt clip can be mounted to tool belts,
bags, buckets, etc. To mount the belt clip:
1. Pull up the clamp release. The clamp
will pop out.
2. Slide the clamp over the tool belt, bag,
bucket, etc.
3. Press in the clamp to tighten.
Using the Clip-Lok Tool Holder
1. To attach the tool to the belt clip, slide
the tool holder over the stud on the belt
clip until it is held in place by the protrud-
ing pin.
2. To release the tool from the belt clip,
grasp the tool handle, push down on
the tool release lever with your thumb,
and pull up on the tool.
Belt clip
Tool release lever
Stud
Pin
Clamp
Clamp
release
Tool holder
Front tangs
MAINTENANCE
WARNING
To reduce the risk of injury,
always unplug the charger and
remove the battery pack from
the charger or work light before
performing any maintenance. Never
disassemble the work light, bat-
tery pack or charger. Contact a
MILWAUKEE service facility for ALL
repairs.
Maintain Work Light
Keep your work light, battery pack and
charger in good repair by adopting a
regular maintenance program.
If the work light does not work prop-
erly, return the work light to a MILWAUKEE
service facility for repairs.
ACCESSORIES
Always remove battery pack before
changing or removing accessories.
Only use accessories specifi cally
recommended for this tool. Others
may be hazardous.
WARNING
For a complete listing of accessories refer to
your MILWAUKEE Electric Tool catalog or go
on-line to www.milwaukeetool.com. To obtain
a catalog, contact your local distributor or a
service center listed on the back cover of this
operator’s manual.