Milwaukee m12 cpd Drill User Manual


  Open as PDF
of 12
 
OPERATION
WARNING 7RUHGXFHWKHULVNRILQMXU\
ZHDUVDIHW\JRJJOHVRUJODVVHVZLWKVLGH
VKLHOGV
WARNING $OZD\VUHPRYHEDWWHU\
SDFNEHIRUHFKDQJLQJRUUHPRYLQJDFFHV-
VRULHV2QO\XVHDFFHVVRULHVVSHFLILFDOO\
UHFRPPHQGHGIRUWKLVWRRO2WKHUVPD\EH
KD]DUGRXV
6HOHFWLQJ+DPPHU'ULOORU'ULYH$FWLRQ
1. 7RXVHWKHKDPPHUGULOOLQJ
mode, rotate the application
selector collar until the hammer
symbol
appears in line with
the arrow. Apply pressure to the
bit to engage the hammering
mechanism.
127(The number selected on the torque
selector collar has no effect on operation of the
drill in hammer mode.
127(When using carbide bits, do not use wa-
ter to settle dust. Do not attempt to drill through
steel reinforcing rods. This will damage the
carbide bits.
2. 7RXVHWKHGULOOLQJRQO\PRGH,
rotate the application selector
collar until the drill symbol
appears in line with the arrow.
127(The number selected on
the torque selector collar has no
effect on operation of the drill in
drilling mode.
3. 7RXVHWKHGULYLQJVFUHZV
mode rotate the application
selector collar until the drive
symbol
appears in line with
the arrow. Then rotate the torque
selector collar until the desired
clutch setting appears in line with
the arrow.
The adjustable clutch, when properly adjusted,
will slip at a preset torque to prevent driving the
screw too deep into different materials and to
prevent damage to the screw or tool.
)XHO*DXJH
To determine the amount of charge left in the bat-
tery, pull the trigger. The Fuel Gauge will light up
for 2-3 seconds.
To signal the end of charge, 1 light on the fuel
gauge will Àash for 2-3 seconds.
,QVWDOOLQJ%LWV
Always remove the battery before inserting or
removing bits. Select the proper style and size bit
for the job.
This tool is equipped with a spindle lock. The chuck
can be tightened with one hand, creating higher grip
strengths on the bit.
1. To open the chuck jaws, turn the sleeve in the
counterclockwise direction.
When using drill bits, allow the bit to strike the
bottom of the chuck. Center the bit in the chuck
When using screwdriver bits, insert the bit far
enough for the chuck jaws to grip the hex of the
bit.
2. To close the chuck jaws, turn the sleeve in the
clockwise direction. The bit is secure when the
chuck makes a ratcheting sound and the sleeve
can not be rotated any further.
3. To remove the bit, turn the sleeve in the coun-
terclockwise direction.
127( A ratcheting sound may be heard when the
chuck is opened or closed. This noise is part of the
locking feature, and does not indicate a problem
with the chuck’s operation.
jaws and lift it about PP1/16” off of
the bottom.
 previous next