Filter
Top Products
8
Terminal
block
screw
Ground wire
Power
cable
Terminal
block
4
Hole
Power cable
Power cable
5
70mm
15mm
Power cable hole
Power cable
Mounting
screw
Cord clip
(Included)
Cord clip mounting screw hole
2.Screw the power cable to the terminal block.
Proper torque is 1.2Nm(11 lbf·in)
Screw
Power cable
Installation (Continued)
Run the power cable through the hole in the back
of the appliance, and pull it through the appliance.
Wire it to the terminal block. (No polarity)
1.Remove 15mm of wire sheath
from the end.
3
.Check that the power cable is securely fixed
to the terminal block.
4.Wire the ground wire to the center terminal
of the terminal block.
Proper torque is 1.2Nm(11 lbf·in)
5.Clip and screw the power cable into the
position shown on the right.
Use singlephase 220240V power.
Using the incorrect power supply may cause fires, electric shocks or
malfunctions.
Terminal
block
Warning