Filter
Top Products
4
Mr. Heater | Propane Torch Operating Instructions and Owner’s Manual
1) Unpack all the components and inspect for any damage. If any damage is
discovered contact the delivery service or Mr. Heater immediately.
2) Connect the hose assembly to the handle assembly and tighten
counterclockwise.
NOTE: This is a left-handed thread connection.
Connection to the Supply Tank:
NOTE: The LP (Liquid Petroleum) gas tank used with this device should be no less than a
20 lb. capacity. It should also meet or exceed NFPA 58 “Standard for the Storage and
Handling of Liquefied Petroleum Gases”.
1) Inspect the nut/nipple (excess shut-off valve) connection of the hose assembly.
Check for any dents or damage. The o-ring must be present. If damage is found
or the o-ring is missing call Mr. Heater for the proper replacement parts.
2) Connect the excess shut-off valve end of the host assembly to the shut-off valve
of a LP gas tank and tighten counterclockwise.
NOTE: If your LP gas tank does not have a shut-off valve, exchange the tank for
one with a shut-off valve.
OPERATING CHARACTERISTICS
Model BTU Operating Inlet Pressure
Temperature Range Range
MH500PT 500,000* -10
o
F to 100
o
F 17 psi to 170 psi
Assembly Instructions:
Un-assembled
Assembled
CAUTION:
This device is designed for vapor withdrawal from an LP gas tank(s) ONLY. Use of any
other gas may result in device failure or personal injury.
* Tank size and tank temperature can directly affect BTU output