Multiquip AR13HA Welder User Manual


 
AR13HA-R RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #9 (06/28/11) — PAGE 21
AR13HA-R RIDE-ON ROLLER — ENGINE COMPONENTS
Operating the engine without an air
filter, with a damaged air filter, or a filter
in need of replacement will allow dirt
to enter the engine, causing rapid
engine wear.
Figure 6. Honda GX610 Engine Controls and Components
INITIAL SERVICING
The engine (Figure 6) must be checked for proper lubrication and
filled with fuel prior to operation. Refer to the manufacturer's engine
manual for instructions & details of operation and servicing.
1. Oil Drain Plug – Remove to drain crankcase oil. Fill with
recommended type oil as listed in Table 4.
2. Oil Filter – Spin-on type, filters oil for contaminants.
3. Spark Plug – Provides spark to the ignition system. Set
spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean
spark plug once a week.
4. Lifting Hook Eye – Attach a lifting device of adequate
lifting capacity at this lifting point whenever lifting of the
engine is required.
5. Fuel Filter – Prevents dirt and other debris from entering
the fuel system..
6. Air Filter – Prevents dirt and other debris from entering the
fuel system. Unsnap air filter cover to gain access to filter
element.
7. Oil Filler Cap – Remove to add engine oil.
8. Oil Dip Stick – Remove to check amount and condition of
oil in crankcase. Refill or replace with recommended type
oil as listed in Table 4.
9. Starter – Starts engine when ignition key is rotated to the
"ON" position.
Engine components can generate extreme heat.
To prevent burns, DO NOT touch these areas
while the engine is running or immediately after
operating. NEVER operate the engine with the
muffler removed.
WARNING - BURN HAZARD
NOTE