Filter
Top Products
PAGE 14 — MT85HS RAMMER — OPERATION AND PARTS MANUAL — REV. #9 (01/16/12)
5. If engine fails to start, move the choke lever (Figure 5) to the
half open position to avoid flooding.
6. Repeat steps 1 thru 5.
7. If the engine does not start after repeated attempts,
check the spark plug for excess fuel. Clean and replace
the spark plug as needed.
Figure 6. Engine On/Off Switch
Figure 7. Recoil Starter
2. Set the engine ON/OFF switch (Figure 6) to the "ON"
position (start).
Figure 5. Fuel Cock and Choke Lever
3. Close the choke lever (Figure 5) and move the throttle lever
(Figure 9) to the "Full Open" position. Turning the choke
lever 90 degrees clockwise closes the choke . In cold weather,
start the unit with choke fully closed. In warm weather or when
the engine is warm, the unit can be started with choke halfway
or completely open.
4. Grip the recoil starter (Figure 7) handle and pull it until you
feel a slight resistance. Then pull sharply and quickly. Return
the recoil starter handle to the starter position before releas-
ing.
Inspection
1. Check all nuts, bolts fasteners for tightness. Retighten as
necessary.
2. Clean any dirt from the recoil starter and foot pedestal. Wipe
the entire unit clean before operating.
3. Replace any missing or damaged Safety Operation decals.
4. Adjust height of handle. Adjust handle by loosening nuts and
moving handle to suit operation. Retighten nuts.
Initial Start-up
When starting the MT-85HS Tamping Rammer perform the
following:
1. Open the fuel shut- off valve by moving the
fuel cock
lever
to the
open
position (Figure 5).
edarGliOrotoM.3elbaT
erutarepmeTronosaeS
liorotomfoedarG
)ssalcSMnahtrehgih(
nmutuAroremmuS,gnirpS
F°51+otF°021+
03EAS
retniW
F°5
1+otF°04+
03EAS
F°51+woleB03-W01EAS
OPERATION