Multiquip MVC-64H Biscuit Joiner User Manual


 
l
PAGE 20 — MVC-64H/HW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #5 (03/01/07)
Inspection and Maintenance Service Tables.
1. To make sure your plate compactor is always in good
working condition before using, carry out the maintenance
inspection in accordance with Tables 5 through 7.
MVC-64H/HW — MAINTENANCE
KCEHCENIGNE.6ELBAT
)launaMenignEetarapesees,sliatedroF(
metI noitarepOfosruoH
leufroliofoegakaeL )yadyreve(sruoh8yrevE
sdaerhtgninetsaffossenthgiT )yadyreve(sruoh8yrevE
tnemhsinelperdnakcehclioenignE
yreve(sruoh8yrevE
.xamdeificepsothsinelpeR()yad
)level
tnemhsinelperlioenignE
001yreveneht,sruoh02tsriftA
sruoh
gninaelcrenaelcriA sruoh05yrevE
.7ELBAT
retemaiD)mc/gk.ni(EUQROTGNINETHGIT
lairetaM
mm6 mm8 mm01 mm21 mm41 mm61 mm81 mm02
T4 07 051 003 005 057 001,1 004,1 000,2
T8-6 001 052 005 008 003,1 000,2 007,2 008,3
T11 051 004 008 002,1 000,2 009,2 002,4 006,5
* )mm01(007~056)mm8(053~003)mm6(001
)munimulafositrap-retnuocesacnI(*
)dednahthgirllaeraenihcamsihthtiwesunisdaerhT(
,tlobhcaenodekramsilairetamfoytilauqdnalairetaM
.wercsdna
Engine Oil Replacement:
1. Replace engine oil, in first 20 hours of operation and every
100 hours afterwards.
2. Oil may be drained more easily when it is warm after
operation (For more details, see separate HONDA Owner's
Manual).
3. When changing the engine oil, the old oil can be drained by
removing the oil filler cap, and unscrewing the engine oil
drain plug located at the base of the engine (Figure 16).
4. Remember to refill engine crankcase with the recommended
type of oil as listed in Table 4.
z
Check for leakage of fuel or oil.
z
Remove soil and clean the bottom of compaction plate.
z
Check engine oil, see page 16.
z
Check for loose screws including tightness. See Table 7
below (tightening torque ), for retightening:
Daily Service
Inspection and other services should
always
be carried out
on hard and level ground with the engine shut down.
CAUTION - Inspection
These inspection intervals are for operation under normal
conditions. Adjust your inspection intervals based on the
number of hours plate compactor is in use, and particular
working conditions.
CAUTION - Inspection Intervals
CAUTION - Inspection Intervals
Fuel piping and connections should be replaced every 2
years.
H46-HVM.5ELBATNOITCEPSNIENIHCAM
METI
FOSRUOH
NOITAREPO
SKRAMER
straPdegamaD
sruoh8yrevE
)yadyreve(
swercStsoLroesooL
sruoh8yrevE
)yadyreve(
gni
llortnoCfonoitcnuF
traPmetsyS
sruoh8yrevE
)yadyreve(
kcehCliOrotarbiVsruoh001yrevE61egapeeS
liOrotarbiV
tneme
calpeR
sruoh003yrevE12egapeeS
kcehC)hctulc(tleb-Vsruoh002yrevE12dna71segapeeS