Filter
Top Products
Reference Manual for the Model FVS318 Cable/DSL ProSafe VPN Firewall
3-8 Preparing Your Network
Verifying TCP/IP Properties (Macintosh)
After your Macintosh is configured and has rebooted, you can check the TCP/IP configuration by
returning to the TCP/IP Control Panel. From the Apple menu, select Control Panels, then TCP/IP.
The panel is updated to show your settings, which should match the values below if you are using
the default TCP/IP settings that NETGEAR recommends:
• The IP Address is between 192.168.0.2 and 192.168.0.254
• The Subnet mask is 255.255.255.0
• The Router address is 192.168.0.1
If you do not see these values, you may need to restart your Macintosh or you may need to switch
the “Configure” setting to a different option, then back again to “Using DHCP Server”.
Your Internet Account
For access to the Internet, you need to contract with an Internet service provider (ISP) for a
single-user Internet access account using an external broadband access device such as a cable
modem or DSL modem. This modem must be a separate physical box (not a card) and must
provide an Ethernet port intended for connection to a Network Interface Card (NIC) in a PC. Your
firewall does not support a USB-connected broadband modem.