Filter
Top Products
ENGLISH
Charge the battery of the other device
You can use the DC-11 device to
charge the battery in two devices
at the same time.
The fully charged DC-11 device has
enough power to fully charge a
950 mAh battery once.
1. If the charger plug you want to
use is inserted into the end of the
DC-11 device, pull the plug out
from the recess, and uncoil the
charging cable from the side of
the device.
2. Connect the charger plug to the
other device.
3. Press the power key of the DC-11
device.
The indicator light flashes during
charging. If the light does not
flash, check that the other device is
properly connected to the DC-11
device. If the light is not displayed,
charge the DC-11 device, and press
the power key to switch it on.
If the DC-11 device cannot start
charging the other device within
about 30 seconds, the DC-11
device switches off.
4. Check the charge level from the
connected device.
5. When the battery in the other
device becomes fully charged, the
indicator light stops flashing and is
continuously shown for about
30 seconds, and the DC-11 device
switches off. You can also stop
charging and switch off the DC-11
device by pressing and holding the
power key for about 5 seconds. The
DC-11 device automatically
switches off if it becomes
discharged.