Filter
Top Products
12
With the blade teeth facing forward, insert the blade into the
blade holder as far as it will go. Make sure that the back edge
of the blade fits into the roller. Then tighten the screw clock-
wise to secure the blade.
To remove the blade, follow the installation procedure in
reverse.
NOTE:
• Occasionally lubricate the roller.
Installing the universal shank jig saw blade
If the universal blade clamp is used, you can use blades of
other makes which have a universal shank like the one
shown in the figure, with a blade width of 6.35 mm (1/4”).
Insert the blade into the blade holder as far as it will go. Make
sure that the end of the blade shank reaches the bottom of
the inner slit and tighten the bolt securely with the hex
wrench.
Anti-splintering device
For splinter-free cuts, the anti-splintering device can be used.
To install the anti-splintering device, move the base all the
way forward and fit it into the base from the back of base.
NOTE:
• The anti-splintering device cannot be used when making
bevel cuts.
1. Screw
2. Roller
3. Jig saw blade
1
2
3
002718
6.35mm(1/4”)
002725
1. Blade holder
2. Bolt
1
2
002726
1. Base
2. Anti-splintering device
1
2
002733