Filter
Top Products
7
To stop the tool from the locked position, pull the switch trig-
ger fully, then release it.
Reversing switch action
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the position
(A side) for clockwise rotation or the position (B side) for
counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
Pull the locator out of the locking sleeve while turning the
locator slightly. Then grasp the bit with a pair of pliers and
pull the bit out of the magnetic bit holder. Sometimes, it helps
to wiggle the bit with the pliers as you pull.
To install the bit, push the bit firmly into the magnetic bit
holder. Then install the locator by pushing it firmly onto the
locking sleeve while turning the locator slightly.
1. Reversing switch lever
1
A
B
002634
1. Locator
2. Locking sleeve
1
2
002652
1. Bit
2. Magnetic bit holder
1
2
002660