Filter
Top Products
IMPORTANT SAFETY
lNSTRUCTIONS
I.
1)
SAVE THESE
INSTRUCTIONS-This
manual contains important safety and
operating instructions for battery
charger EY0005.
2)
Before using battery charger, read all
instructions and cautionary markings
on battery charger, battery pack, and
product using battery pack.
3)
CAUTION-To reduce the
risk of injury, charge only Panasonic
Battery Pack as shown in last page.
Other types of batteries may burst
causing personal injury and damage.
4)
Do not expose charger to rain or snow.
5)
To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6)
Make sure cord is Iocated so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
7)
An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric
shock. If extension cord must be used,
make sure that:
a.
pins on plug of extension cord are
the same number, size and shape
as those of plug on charger.
b.
extension cord is properly wired and
in good electrical condition.
c.
wire size is large enough for ampere
rating of charger as specified below.
8)
Do not operate charger with damaged
cord or plug — replace them
immediately.
9)
Do not operate charger if it has received
a sharp blow, been dropped, or
otherwise damaged in any way; take it
to a qualified personnel.
10)
Do not disassemble charger; take it to
a qualified personnel when service or
repair is required. Incorrect reassembly
may result in a risk of electric shock or
fire.
11)
To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or cleaning.
12)
The charger and battery pack are
specifically designed to work together.
Do not attempt to charge any other
cordless tool or battery pack with this
charger.
13)
Do not attempt to charge the battery
pack with any other charger.
14)
Do not attempt to disassemble the
battery pack housing.
15)
Do not store the tool and battery pack
in locations where the temperature may
reach or exceed 50°C (122°F) (such a
metal tool shed, or a car in the summer),
which can lead to deterioration of the
storage battery.
16)
Do not charge battery pack when the
temperature is BELOW 0°C (32°F) or
ABOVE 40°C (104°F). This is very
important in order to maintain optimal
condition of the battery pack.
17)
Do not incinerate the battery pack.
It can explode in a fire.
18)
Avoid dangerous environment. Do not
use charger in damp or wet locations.
19)
The charger is designed to operate on
standard household electrical power
only. Do not attempt to use it on any
other voltage!
20)
Do not abuse cord. Never carry charger
by cord or yank it to disconnect from
outlet. Keep cord away from heat, oil
and sharp edges.
21)
Charge the battery pack in a well
ventilated place, do not cover the
charger and battery pack with a cloth,
etc., while charging.
22)
Use of an attachment not recommended
may result in a risk of fire, electric shock,
or injury to persons.
23)
Do not short the battery pack. A battery
short can cause a large current flow,
over heating and create the risk of fire
or personal injury.
24)
NOTE: If the supply cord of this
appliance is damaged, it must only be
replaced by a repair shop authorized
by the manufacturer, because special
purpose tools are required.
25)
TO REDUCE THE RISK OF ELECTRIC
SHOCK, THIS APPLIANCE HAS A
POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
CHARGING THE
BATTERY
II
.
NOTE:
•
When you charge the battery pack for
the first time, or after prolonged
storage, charge it for about 24 hours
to bring the battery up to full capacity.
1.
Plug the charger into the AC outlet.
NOTE:
•
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
2.
Insert the battery pack firmly into the
charger.
3.
During charging, the charging lamp will
be lit.
When charging is completed, an internal
electronic switch will automatically be
triggered to prevent overcharging.
•
Charging will not start if the battery
pack is too warm (for example,
immediately after heavy-duty operation).
The charging lamp will be red flashing
until the battery cools down. Charging
will then begin automatically.
4.
When charging is completed, the charging
lamp will start flashing quickly.
5.
If the charging lamp does not light
immediately after the charger is plugged
in, or if after the standard charging time
the lamp does not go off, consult an
authorized dealer.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating.
Amperes AWG Size of Cord
Equal to or But less Length of Cord, Feet
greater than than 25 50 100 150
0 2 18 18 18 16
Battery pack
To AC
outlet
Battery charger
— 2 — — 3 —
English English