Filter
Top Products
Ref. No. 3G Procedure 3A →
→→
→ 3B →
→→
→ 3C →
→→
→ 3D →
→→
→ 3E →
→→
→ 3F
→
→→
→ 3G
Assembly of the blade guard assembly.
1. Set the safty cover B with connecting the transparent guard and
tighten the 3 screws. (EY3552)
2. Hang the one side of spring (without marking side) on the safety
cover B.
3. Lightly greasing (ALVANIA) around the internal diameter and the
external diameter on the rear side of the lower guard.
4. Hang the other side of spring on the lower guard and set it to the
main unit.
5. Set the stop ring.
NOTE:
The stop ring has its own direction for assembly. Make sure that
the rounded side faces housing.
And make sure that 2 holes of stop ring should be placed upper
right.
6. Set the safety cover A and tighten the 3 screws with 25kgfcm.
7. Set the inner washer and carefully set the blade.
8. Set the outer washer and tighten the hex bolt using the provided
hex wrench with holding the spindle lock button.
Ref. No. 3H Procedure 3A →
→→
→ 3B →
→→
→ 3C →
→→
→ 3D →
→→
→ 3E →
→→
→ 3F
→
→→
→ 3G →
→→
→ 3H
Assembly of the motor housing.
1. Return the brush spring into the groove of the motor brush on
both sides.
2. Attach the housing C and tighten the 2 screws with 15kgfcm.
11
EY3551-U1 / EY3552-U1