Filter
Top Products
-
9
-
. ACCESSORIES
CAUTION:
To prevent the risk of injury, only use accessory or attachment for its stated purpose.
Bit adapter
•EY9HX403
Drill chuck (Optional accessory)
•EY9HX400
Hammer chuck (Optional accessory)
•EY9HX401
Battery pack
•EY9201(Ni-MH)
Battery charger
•EY0110
If you need any assistance for more details regarding these accessories, ask your
local service center.
. USAGE SUGGESTION
1. If there isn’t enough force pushing down on the bit, the hammer may not be able to
blow in hammering mode.
This is to prevent the hammering mode from operating with no load. Press down
harder on the bit to engage the hammer and cause it to blow.
Always be sure to press down with enough force when working.
2. In winter or in other situations where the temperature of the unit is low (5°C or
below), the blow of the hammering mode may be weaker than normal at the
beginning stage.
This is because the grease becomes stiffer in low temperatures, increasing friction.
If this should happen, operating hammering mode with no load for approximately
30 seconds and repeat this 3 times. This will restore its blowing power.
. SPECIFICATIONS
MAIN UNIT (EY6803)
Maximum drilling
diameter
Concrete
10 mm (25/64") *12.5 mm (15/32")
*For work that can be completed with one battery pack.
Steel
13 mm (33/64")
Motor voltage 12 V DC
Speed at no load (RPM) 0
-
1000 /min (rpm)
Blows rate per minute (BPM) 0
-
4000 /min (bpm)
Weight (with battery pack) 2.5 kg
(5.5 lbs)
Dimensions (L×W×H) 249×257×64 mm (10"×10
-
1/8"×2
-
1/2")
EY6803(EU).indb 9 2006/04/10 9:41:34