Filter
Top Products
Ref. No. 2G Procedure 2A →
→→
→ 2B →
→→
→ 2C→
→→
→ 2D→
→→
→ 2E→
→→
→ 2F→
→→
→
2G
Attachment of the Housing.
1. Place the driving block onto the housing A and place the spring
for release lever and the hook release lever.
2. Place the switch assembly, operation panel, click spring and F/R
selector handle onto the housing A.
NOTE :
Make sure that the lead wires are pressed fit firmly.
3. Close the housing A and B with pushing the radiating plate on the
direction of the arrow and tighten 8 housing screws.
NOTE :
Confirm to set the radiating plate properly. If the radiating plate
lean toward the motor brush side, the housing B can not be
closed.
4. Place the H/L change handle into the rail properly.
5. Insert the belt hook into the housing and tighten with hook bolt.
8
EY7440-U1 /