Filter
Top Products
operation was confirmed
(page 14).
Inserting the battery
R USE ONLY a CR2 Lithium battery.
R Confirm the polarities (
, ).
1 Remove the sensor unit cover.
R Lift from the indented area (A)
and open the sensor unit cover
(B).
1
2
2 Insert the battery.
3 Attach the sensor unit cover.
Registering the
window/door sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the window/door
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1 Hub:
Press and hold M OTHER
DEVICEN until the LED indicator
blinks in green.
2 Window/door sensor:
Remove the sensor unit cover and
press and hold M N until the
LED indicator blinks in green
(page 8).
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel registration, press M N
on the hub and on the window/door
sensor.
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the window/door
sensor by using the [Home Network]
app, you can assign a name to your
For assistance, please visit www.panasonic.com/support
9
Setup