Panasonic TH-58AX800A Work Light User Manual


 
English
15
For the information of the camera operation, refer
to [eHELP] (Functions > Built-in Camera).
2 Lens part
3 Angle adjuster
Adjusts the angle of lens.
4 Remote control signal receiver
Do not place any objects between the TV remote
control signal receiver and remote control.
5 Ambient sensor
Senses brightness to adjust picture quality when
[Ambient Sensor] in the Picture Menu is set to
[On].
6 Power LED
Red: Standby
Green: On
Orange: Standby with Recording / Standby with
Timer Programming On / Standby with
Info Bar On
The LED blinks when the TV receives a command
from the remote control.
7 Human activity sensor
For the information of the sensor operation, refer to
[eHELP] (Functions > Info Bar).
8 Input mode selection
Press repeatedly until you reach the desired mode.
[Main Menu]
Press and hold for about 3 seconds to display main
menu.
OK (when in the menu system)
9 Channel Up / Down
Cursor Up / Down (when in the menu system)
10
Volume Up / Down
Cursor Left / Right (when in the menu system)
11
Mains power On / Off switch
Use to switch the mains power.
Installing / Removing batteries
Slide open
Note the correct
polarity (+ or -)
Close
Note
It is recommended to hold Touch Pad Controller with
your hand when using.
The battery power will be used whenever you use
Touch Pad Controller (including the touch of the touch
pad) even if not operating the TV. It may decrease the
battery life.
Some operations differ depending on the application.
Indicator / Control panel
When pressing 8, 9, 10 buttons, the control panel
guide appears on the right side of the screen for 3
seconds to highlight the pressed button.
11
456
21 3
9
8
10
7
Rear side of the TV
24 mm
1 Built-in Camera
Automatically comes out and back in by the
operation of a camera application.
Do not pull or push the camera by hands.