Filter
Top Products
9 GB/IE/CY
General safety advice for electrical power tools
b) Do not use an electrical power tool if
its switch is defective. An electrical power
tool that can no longer be switched on and off
is dangerous and must be repaired.
c) Pull the mains plug out of the socket
before you make any adjustments to
the device, change accessories or when
the device is put away. This precaution is
intended to prevent you from unintentionally
starting the device.
d)
When not in use always ensure that
electrical power tools are kept out of
reach of children. Do not let anyone use
the device if he or she is not familiar
with it or has not read the instructions
and advice. Electrical power tools are dan-
gerous when they are used by inexperienced
people.
e) Look after the device carefully. Check
that moving parts are working prop-
erly and move freely. Check for any
parts that are broken or damaged
enough to detrimentally affect the
functioning of the device. Have dam-
aged parts repaired before you use the
device. Many accidents have their origins in
poorly maintained electrical power tools.
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice,
and the stipulations drawn up for this
particular type of device. In doing
this, take into account the working
conditions and the task in hand. The
use of electrical power tools for purposes other
than those intended can lead to dangerous
situations.
Safety advice relating
specifically to Electric
nailer / staplers
½ DANGER OF INJURY! Never
point the device at yourself or at oth-
er people or animals. Ensure that no
people or animals are on the other side of the
workpiece.
½ Protect your eyes! Wear protec-
tive glasses. This also applies to
people who may be helping with the
work by supporting or holding the workpiece.
½ Make sure the device is switched off before
you load the magazine. Set the ON / OFF
switch to position “0” and pull the mains plug
out of the mains socket!
½ Do not use the device to fix electrical cabling
in place.
½ Secure the workpiece. A workpiece held in a
clamp or vice is kept more securely in place
than one held by your hand.
½ Always work with the mains lead leading
away from the rear of the device.
½ DANGER OF INJURY! Use the device with
only the staples and nails specified above. En-
sure that the staples or nails do not project
from the surface of the workpiece or penetrate
through to the other side.
½ Short-term operation time: Let the device cool
down after 15 minutes of continuous opera-
tion.
½ DANGER OF INJURY! Keep your fingers and
other body parts away from the front plate
7
.
½ Never fire staples or nails through the air. At
short range the shot staples or nails could lead
to serious injury.
½ Only soft materials such as wood or textiles
should be joined using the device. Otherwise
the device could be damaged.
CAUTION! Connect the device to the mains
only when it is switched off. Set the ON / OFF
switch
2
to position “0”.
WARNING!
DANGER OF INJURY!
Switch the device on just before you intend to
use it. If you are not using the device, switch it
off to prevent unintentional firing.