Filter
Top Products
6 GB/IE/CY
Introduction
Modelling and engraving set
PMGS 12
Q
Introduction
Please make sure you familiarise yourself
fully with the way the device works before
you use it for the first time and that you
understand how to handle electrical power tools
correctly. To help you do this please read the accom-
panying operating instructions. Keep these instructions
in a safe place. If you pass the device on to anyone
else, please ensure that you also pass on all the
documentation.
Q
Proper use
The small drill is to be used for drilling, milling, en-
graving, polishing, cleaning up, grinding, separating
and sawing of wood, metal, plastic, ceramic or stone
in dry rooms. Any other use or modification to the
drill / grinder shall be considered as improper use
and could give rise to considerable dangers. The
manufacturer will not accept liability for loss or
damage arising from improper use. Not intended
for commercial use.
Q
Features and equipment
Small drill:
1
ON / OFF switch / Rotational speed control
2
Metal stirrup hanger
3
Plug for mains adapter
4
Clamping nut
5
Spigot nut
6
Spindle lock
The following pictograms are used in these operating instructions / on the device:
Read instruction manual!
Keep children away from electrical
power tools!
V
~
Volt (AC)
Caution – electric shock!
Danger to life!
W
Watts (Effective power) For indoor use only!
Direct current
(Type of current and voltage)
Risk of loss of life by electric shock from
damaged mains lead or mains plug!
n
0
Design no-load speed
Wear hearing protection, dust
protection mask, protective glasses
and protective gloves.
mA
A / Ah
Milliamps / Amps / Amp-hours
Avoid contact with rapidly
rotating tools!
Safety class II Risk of fire!
Observe caution and safety notes! Proper procedure and handling.
Risk of explosion!!
Dispose packaging and appliance in
an environmentally-friendly way!
33382_MODELLING AND ENGRAVING SET_Content_LB6.indd 6 27.07.09 14:33