Filter
Top Products
10 GB/IE
make sure that your footing is secure.
Using both your hands to hold electrical tools
ensures safer operation of them.
½ If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback.
½ Always keep the device clean, dry
and free of oil or grease.
½ Only handle the electrical tool by
means
of the insulated handling surfaces
when
you are carrying out jobs where the
insertion tool may come into contact
with hidden power supply lines or its
own power cable. Contact with a live elec-
trical wire also makes metal parts of the electrical
tool live and leads to electric shock.
½ Keep your workplace clean and tidy.
Mixing materials is particularly dangerous.
Dust from light metals can burn or explode.
½ Wait until the electrical tool has come
to a standstill before putting it down.
The insertion tool could get caught up in some-
thing and this may lead to control of the electrical
tool being lost.
©
Caution utility services!
DANGER! Ensure that you do not strike
electrical cables, gas or water pipes when
you are working with the electrical power
tool. Check a wall using a suitable detector before
you drill or cut slots.
©
Original accessories /
attachments
Use only the accessories and attachments
detailed in the operating instructions.
The use of inserted tools or accessories other than
those recommended in the operating instructions
could lead to you suffering an injury.
©
Before first use
WARNING!
DANGER OF INJURY! Switch
the device off and pull the plug out of the mains
socket before carrying out any work on the device.
©
Attaching the auxiliary handle
NOTE: For safety reasons this tool must always be
used with the auxiliary handle
10
in place.
˽ Turn the wing screw
9
anti-clockwise and swivel
the additional handle
10
into the desired position.
˽ Then tighten the wing screw
9
again.
©
Using the depth stop
˽ Open the wing screw
9
.
˽ Make sure that the toothing on the depth stop
8
is pointing downwards.
˽ Pull the depth stop
8
out as far as necessary
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
˽ Firmly tighten the wing screw
9
.
©
Inserting tools
Quick-action drill chuck:
˽ Take firm hold of the back casing
3
of the
quick-action drill chuck
1
and turn the front
casing
2
until the tool can be inserted.
˽ Insert the tool.
˽ Take firm hold of the back casing
3
of the
quick-action drill chuck
1
and turn the front
casing
2
firmly shut.
Assembly tools for screws and nuts:
˽ When using screwdriver bits, always use a
universal bit holder.
˽ To screw things in, always switch the changeover
switch “drill / percussion drill”
4
to the right to
position
.
General safety advice for … / Before first use