Filter
Top Products
9 GB/IE
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.
Safety instructions for
motor carving devices
In order to avoid injury, fire and health
hazards:
½ Secure the work piece. Use clamping
devices / a vice to hold the work piece.
It is then held more securely than with your hand.
½
Wear protective goggles!
There is a danger of injury from
splintering materials flying into your
eyes etc.
½
Wear a dust mask! During pro-
longed working with wood and par-
ticularly if materials are processed
which produce dusts that are hazardous to the
health.
½ Do not soak materials or areas which
are to be worked on with solvent-con-
taining liquids. Shaving of the materials may
produce harmful / toxic vapours.
½ Material containing asbestos must not
be processed with this device. Asbestos
is a known carcinogen.
½ Under no circumstances should you
prop up your hands next to or in front
of the device or the area to be worked
on. There is a danger of injury from the very
sharp attachment tools.
½ Always route the cable towards the back away
from the device.
½ In cases of danger remove the plug from the
socket immediately.
©
Original Accessories /
Additional Equipment
½ Use only the accessories and additional
equipment referred to in the instruc-
tions. The use of tools or other accessories
which are not recommended in the instructions
may represent a risk of injury.
©
Operation
©
Turning the Device On / Off
˽ Insert the mains plug into a socket.
Switching on:
˽ Press the ON / OFF switch
1
to the “I”
position.
Switching off:
˽ Press the ON / OFF switch
1
to the “0”
position.
©
Inserting / Replacing Blades
WARNING!
DANGER OF INJURY!
Before performing any work on the device, turn the
device off and remove the mains plug.
WARNING!
DANGER OF INJURY! The
carving blades have a very sharp edge.
½
During assembly and the final check
of the blade you should wear ap-
propriate protective gloves.
The selection of the correct carving blade depends
on the specific application. The carving blades sup-
plied are suitable for the most common applications
(see Figures B - D).
˽ Release the cap nut
6
with the key
8
in an
anticlockwise direction.
˽ Remove the blade if necessary. Insert another
blade into the tool holder
5
as far as it will go.
˽ Re-tighten the cap nut
6
with the key
8
in a
clockwise direction.
General safety advice for electrical power tools / Operation