Filter
Top Products
10 GB/IE
½
The appliance must always be kept
clean, dry and free of oil or lubricat-
ing greases.
©
Original ancillaries / and
accessories
½ Only use accessories and tools that
are specified in the operating instruc-
tions. The use of tools and accessories other
than those recommended in the operating in-
structions could lead to an increased risk of
personal injury for you.
©
Operation
©
Switching On and Off
Switching on intermittent function:
˽ Press the ON / OFF switch
1
.
Switching off intermittent function:
˽ Release the ON / OFF switch
1
.
Switching on continuous operation :
˽ Press the ON / OFF switch
1
, hold it pressed
and press the locking button
2
.
Switching off continuous operation:
˽ Press the ON / OFF switch
1
then release it
again.
©
Setting the oscillation speed
You can set the desired oscillation speed as need-
ed with the oscillation speed selector
10
.
The required oscillation speed depends on the ma-
terial being worked and can be determined through
practical tests.
©
Attaching a sanding pad
WARNING!
Before performing work on the
appliance, always disconnect the power.
NOTE: Before attaching a new sanding pad
9
,
remove dust and dirt from the sanding plate
8
.
Sanding sheets with hook and loop fas-
tening:
˽ Fix one side of the sanding sheet
9
flush with
one side of the backing plate
8
.
˽ Then attach the sanding sheet
9
to the back-
ing plate
8
and press it firmly into place.
Sanding sheets without hook and loop
fastening:
˽ Open the two clamping levers
7
.
˽ Push one end of the sanding sheet
9
under
the open clamping bar
6
and clamp the
sheet firmly in place by locking the clamping
lever
7
back in place.
˽ Repeat this procedure at the other end.
Various materials require different grit values. You
can read which grit value is best suited for which
work in our recommendations under “Instructions, tips
and tricks”.
©
Vacuuming dust
WARNING!
FIRE HAZARD!
A risk of fire exists when working with
electrical appliances that have a dust
collection box
4
or can be attached to a vacuum
cleaner via an external suction adapter! Under cer-
tain conditions the sanding dust in the dust box (or
in the vacuum’s dust bag) may self-ignite, e.g. as a
result of flying sparks generated when abrading
metals or metal objects left in wood. This can hap-
pen especially if the wood dust has paint particles
on it or is mixed with other chemical substances
and the sanded material is hot after extensive work-
ing. You should therefore avoid overheating of
products being sanded as well as the appliance
and always empty the dust collection box
4
or
the dust bag of the vacuum cleaner before work
pauses.
Wear a dust mask!
General safety advice for electrical power tools / Operation