Filter
Top Products
15 GB/IE
Use / Use of accessories
and the working conditions and can be deter-
mined by means of a practical test.
The table below shows some recommended
settings (for guidance only and given without
liability) for a number of common applications.
The accessories mentioned may not all be sup-
plied as standard with the product. Sawing stone
is only permitted with the use of a cutting guide
(accessory).
Preselected rotation speed:
Material
Application
Tool Setting
Plastic,
varnish
Polishing Lambswool
bonnet
1
Fine finish
Felt polishing
disc
1
Metal Fine finish Buffing disc 1
Paint
removal
Sanding sheet 2-3
Wood,
metal
Brushing,
derusting
Cup brush,
sanding sheet
3
Metal,
stone
Grinding /
abrading
Grinding disc 4-6
Metal Roughing /
grinding
Roughing /
grinding disk
6
Stone Cutting Cutting disc
and cutting
guide
6
©
Changing a disc
½ Always wear protective gloves
when changing cutting or roughing /
grinding discs.
˽ Press the spindle lock button
9
only after the
mounting spindle
7
has reached a standstill,
Fig. A.
˽ Press the spindle lock button
9
to block the
drive.
˽ Release the clamping nut
6
using the spanner
11
, Fig. B.
˽ Place the roughing, grinding or cutting disc on
to the mounting flange
8
with its labelled side
facing towards the device.
˽ Then replace the clamping nut
6
, with its
raised side facing upwards, on to the mounting
spindle
7
.
˽ Press the spindle lock button
9
to block the
drive.
˽ Tighten the clamping nut
6
again with the
spanner
11
.
Note: Replace a new disc immediately if it runs
unevenly or vibrates after being exchanged.
˽ After replacing a disc let the device run under
no load for 30 seconds as a safety check.
Look out for unusual noises or generation of
sparks.
˽ Check that all the fastenings are correctly
attached.
˽ Pay attention to see that the arrow showing the
direction of rotation on the cutting or roughing /
grinding discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
©
Use of accessories
©
Cutting / roughing discs
You can use the following cutting or roughing/
grinding discs with this device:
Dimensions: ø 125 x 22,2 mm
to max. 6 mm thick
(depressed centre)
Speed: 12000 rpm
Circumferential speed: 80 m / sec
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
12000 rpm
80 m / sec
©
Flap discs for metal
Dimensions: ø 125 mm
Speed: min. 12000 rpm