Filter
Top Products
10 GB
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.
J Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
Q
Original ancillaries /
accessories
J Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an in-
creased risk of personal injury for you.
Q
Before first use
Q
Charging the rechargeable
battery on the device
(see Fig. D)
Note: The battery is supplied partially charged.
Charge the battery for at least three hours before
first use. You can charge the Li-Ion battery at any
time without risk of shortening battery life. Interrupt-
ing the charging process does not damage the
battery.
Starting the charging process:
j
Connect the mains adapter
10
to a 230 / 240 V
~
50 Hz mains socket.
j Connect the mains adapter
10
to the charging
socket on the device
5
.
The rechargeable battery is charged when the
battery indicator
3
changes from red to green.
Ending the charging process:
j Disconnect the mains adapter
10
from the
mains socket.
j Disconnect the mains adapter
10
from the
charging socket on the device
5
.
Q
Changing the bits /
screwdriver bit inserts
Insertion:
j Insert the bit directly into the tool holder
9
.
Removal:
j Pull out the bit out of the tool holder
9
.
Q
Preparing the tool for use
Q
Switching on / off the
cordless screwdriver
Switching on:
j To start the appliance squeeze on the ON /
OFF switch
7
and then keep it pressed down.
Switching off:
j To stop the appliance, release the ON / OFF
switch
7
.
Q
Changing the
direction of rotation
Clockwise:
j Slide the direction of rotation switch
1
to the
left.
j Press the ON / OFF switch
7
. The direction
indicator (clockwise)
2
illuminates. You can
now screw in the screws.
Anticlockwise:
j Slide the direction of rotation switch
1
to the
right.
j Press the ON / OFF switch
7
. The direction in-
dicator (anticlockwise)
4
illuminates. You can
now screw out the screws.
General safety advice for … / Before first use / Preparing the tool for use
35327_LITHIUM ION CORDLESS SCREWDRIVER_Content_LB4 (ohne HU).indd 10 12.08.09 16:41