Porter-Cable 2611 Drill User Manual


 
6
ADDITIONAL SPECIFIC SAFETY RULES
SAVE THESE INSTRUCTIONS!
1. Wear ear protectors with impact drills. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool. Loss of control can cause
personal injury.
3. Hold power tools by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its own
cord. Contact with a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
4. Verify the direction of rotation before starting the tool. Never attempt
to change direction of rotation while switch is “ON”. To do so, may
damage interlock feature built into switch. Be sure switch is “OFF” and
motor has completely stopped before changing direction of rotation.
5. Wear eye and hearing protection. Always use safety glasses.
Everyday eyeglasses are NOT safety glasses. USE CERTIFIED SAFETY
EQUIPMENT. Eye protection equipment should comply with ANSI Z87.1
standards. Hearing equipment should comply with ANSI S3.19 standards.
6. Use of this tool can generate and disburse dust or
other airborne particles, including wood dust, crystalline silica dust
and asbestos dust. Direct particles away from face and body. Always
operate tool in well ventilated area and provide for proper dust removal.
Use dust collection system wherever possible. Exposure to the dust may
cause serious and permanent respiratory or other injury, including silicosis
(a serious lung disease), cancer, and death. Avoid breathing the dust, and
avoid prolonged contact with dust. Allowing dust to get into your mouth
or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure, and wash exposed areas with soap
and water.
SYMBOL DEFINITION
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
F ........................ farads
µF ........................ microfarads
l ........................ litres
g ........................ grams
kg ........................ kilograms
bar ........................ bars
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
n
0
........................ no-load speed
…/min or …min
-
1
......... Revolutions or reciprocations per minute
or d.c. ................ direct current
or a.c. ................ alternating current
2 ........................ two-phase alternating current