Porter-Cable 33-421 Saw User Manual


 
10
STARTER BOX TO BASE
1. Assemble bracket (A) to the bottom of the right side
of saw base, (Fig. 12), using the 1/4-20x1/2" hex head
screw (B), 1/4" lockwasher (D), and 1/4-20 nut (E).
2. Assemble the starter box (B) Fig. 13 to the right side
of the base by inserting the three1/4-20x1/2" hex head
screws (C) with 1/4" lock-washers, through the two
holes in the base and the hole in the bracket and into the
three 1/4-20 weld nuts in the back of the starter box. A
cable clamp is supplied to attach the power cord to saw
frame.
3. Fig. 14 illustrates the starter box assembled to the
base.
Fig. 12
Fig. 13
Fig. 14
B
D
E
TABLE BOARDS AND FENCE
1. Assemble loose table boards and fence (A) Fig. 15, on the table brackets.
2. Assemble three angle supports (B) Fig. 15 to the fixed front table board (C) using nine 1/4-20x7/8" round head
screws and 9/32" flat washers (D).
3. Fig. 16 illustrates three angle supports (B) assembled
to the fixed table board (C).
4. Place the smaller angled table board (D) Fig. 16, on
the angle supports (B) and fasten with six 1/4-
20x7/8" round head screws and 9/32" flat washers
shown at locations (E) Fig. 17.
Fig. 15
Fig. 16
Fig. 17