Filter
Top Products
Fig. 1
1. 3/8-16x1" Hex Head Screw (12)
2. 1/4-20x7/8" Round Head Screw (15)
3. 1/2-20x1/2" Hex Head Screw (4)
4. 3/8" Flat Washer (12)
5. 9/32" Flat Washer (15)
6. 3/8" Lockwasher (12)
7. 1/4" Lockwasher (4)
8. 3/8-16 Hex Nut (12)
9. 1/4-20 Hex Nut (1)
1. Blade Guard (1)
2. Angle Support (3)
3. Blade (1)
4. Cross Stop (1)
5. Track-Arm Lock
Handle (1)
6. 1-1/16" Open End
Wrench (1)
7. Spanner Wrench with a
1-5/8" Box End (1)
8. Roller Head Wrench (1)
9. Anti-kickback Rod (1)
10. Cable Clamp (1)
11. Elevating Crank Handle
(1)
12. Starter Box Bracket (1)
13. Cutterhead Return
Spring (1)
1
2
3
4
5
1
2
3
4
5
6
7
8
9
10
11
12
13
6
7
8
9
Fig. 1a
6
The Long Arm Radial Saws are not supplied with a power cord. They must be permanently connected to the building
electrical system and all wiring must be done by a qualified electrician and conform to the National Electric Code and all local
codes and ordinances. Since they are permanently connected, extension cords cannot be used.
A separate electrical circuit should be used for your machines. This circuit should not be less than #12
wire and should be protected with a 20 Amp time lag fuse.
Deltas Long Arm Radial Saws have a totally enclosed, fan-cooled motor with electro-mechanical blade brake, 18", 16",
or 14" blade guard with anti-kickback attachment, retractable leaf guard, cutterhead return attachment, cuttinghead
clamp knob, adjustable crosscut stop, and steel legs.
POWER CONNECTIONS
GROUNDING INSTRUCTIONS
FOREWORD
FUNCTIONAL DESCRIPTION
NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE CURRENT PRODUCTION MODEL. ALL OTHER
ILLUSTRATIONS CONTAINED IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE ACTUAL COLOR,
LABELING OR ACCESSORIES AND ARE INTENDED TO ILLUSTRATE TECHNIQUE ONLY.
CARTON CONTENTS
* THREE PHASE OPERATION: Three phase machines are not supplied with a power cord and must be permanently
connected to a building’s electrical system. Extension cords can’t be used with a three phase machine.
* LVC MAGNETIC MOTOR CONTROL: Your radial arm saw was shipped with a Low Voltage Magnetic Motor Control
System. Please refer to its instruction manual for installation guidance.
* 460 VOLT OPERATION: If your saw has a dual voltage motor (230/460 volts), and you desire the machine to run at 460
volts, the re-wiring must be done by a qualified electrician and conform to the National Electric Code and all local codes
and ordinances.
MOTOR SPECIFICATIONS
Your machine is wired for 230V, 60HZ alternating current. Check the spec plate on the motor for the horsepower rating,
whether the motor is dual voltage and to determine if your machine is single or three phase.