Filter
Top Products
13
RIP GUIDE
A rip guide (A), Fig. 13, is
available as an accessory.
Install rip guide as follows:
1.
DISCONNECT TOOL FROM
POWER SOURCE.
2. Insert rip guide through
slot in right side of saw base.
Slide the guide in until it
extends through the slot in left
side of base.
3. Position the compression spring to the thumb screw (supplied with the
rip guide), and thread into the hole in the saw base. DO NOT TIGHTEN.
4. Adjust the rip guide for the desired width of cut and tighten the thumb
screw.
To avoid personal injury and damage to workpiece,
the rip guide must always extend through both slots in base.
HOW TO USE THE SAW
For maximum protection of the operator, effective control of this powerful
saw requires two-handed operation.
It is important to support the work properly and to
hold the saw firmly to prevent loss of control which could cause
personal injury. Fig. 14 illustrates proper hand support of the saw.
Clamp work on a rigid support such as a bench or saw horses. See Fig. 14.
Mark the line of cut on the work. Be sure cut-off line is beyond end of support
to the right only enough to allow proper operation of the telescoping guard.
Place front edge of saw squarely on work before starting motor. Sight the
cutting line with the line-of-cut indicator Fig. 9. Back saw up slightly and start
motor. Move saw forward keeping the edge of line indicator parallel to line of
cut.
Keep the cord away from cutting area, so it does not
get hung up in the work being cut. See Fig. 14.
OPERATION
Fig. 13
A
Fig. 14
A