Filter
Top Products
Fig. 16
Fig. 17
←
6
PREPARING THE TOOL
1. After reading and understanding this entire manual, connect tool to
air supply.
CAUTION: Keep tool pointed away from yourself and others at all
times.
Always connect tool to air supply before loading fasteners.
Do not load fasteners with trigger or safety depressed.
Only use approved Porter-Cable fasteners (see ACCESSORIES).
Always wear Z87 approved safety glasses, and hearing protection
when preparing or operating the tool.
Never use a tool that leaks air or needs repair.
2. Depress latch and slide magazine cover open, see Fig. 15.
3. Insert a strip of approved fasteners, see Fig. 16. Orient fasteners with
points down, and in contact with the bottom of the magazine.
4. Push magazine cover closed, see Fig. 17.
5. Adjust directional exhaust deflector (A) Fig.
18, so that the exhaust air blast will be directed
away from the operator. The exhaust deflector
provides 8 detented positions for directing the
exhaust blast away from the operator. Grasp the
deflector and rotate it to the desired position for
the current application.
1
←
→
2
Fig. 14
Fig. 15
Fig. 18
A