Filter
Top Products
5- ENG
D22722
ASSEMBLY
SPECIFICATIONS
OPERATION
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D.
and fittings should have 1/4” NPT thread.
Free Speed 600 RPM
Maximum Working Pressure 90 PSI
Air Inlet 1/4" NPT
Recommended Hose Size 3/8" I.D.
Keyless Chuck 1/2”
Air Consumption @ 90 PSI 6.0 SCFM
Before each use:
●
Drain water from air compressor tank and condensation from air lines. See air
compressor’s operators manual.
Disconnect the tool from the air supply before lubricating or
changing drill bits.
●
Lubricate tool, see “Maintenance” section in this manual.
●
Open the keyless chuck (A), no tools are required.
●
Insert and center drill bit in the jaws (B) as you close chuck.
NOTE: An off centered drill bit will wobble and could break.
●
Connect tool to air hose of recommended size. NOTE: The use
of a quick connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
Trigger
Air Inlet
Chuck
Reverse
and
Forward
Lever
Stabilizer
Handle
Assemble Stabilizer Handle
1. Slide stabilizer handle onto tool, rotate to desired position and tighten.
B
A