Filter
Top Products
-6-
1. Disengage the latch and
pull back magazine side.
2. With magazine fully open
insert fasteners. Points
must be against bottom of
magazine.
3. Push magazine forward.
4. Continue pushing until
latch is engaged.
LOADING THE FN250SB
EYE PROTECTION which conforms to ANSI specifications and provides protection
a
gainst flying particles both from the FRONT and SIDE should ALWAYS be worn
b
y the operator and others in the work area when loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris,
which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
S
tandards Institute,
ANSI Z87.1/CAN/CSA Z94.3 a
nd provide both frontal and side
p
rotection. NOTE: Non-side shielded spectacles and face shields alone do not
provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool
while the air supply is connected.
• Never point the tool at anyone else.
•
Never engage in horseplay.
•
Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE BN200SB
FN250SB-BN200SB_9R198001RA_PC_16GA and 18GA FINISH NAILER MANUAL_MAN_JM3_107674RevE_Manua