Filter
Top Products
3
19. CHECK DAMAGED PARTS. Before further use of the tool, a guard
or other part that is damaged should be carefully checked to determine
that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard
or other part that is damaged should be properly repaired or replaced by
an authorized seNice center unless otherwise indicated elsewhere in this
instruction manual. Have defective switches replaced by authorized
service center. Do not use tool if switch does not turn it on and off.
20. WEAR EAR PROTECTION to safeguard against possible hearing loss.
21. NEVER ADJUST DEPTH OF CUT WHILE MOTOR IS RUNNING. A
slip at this time may cause personal injury, or damage to cutter or
workpiece.
22. BE SURE CORD SET IS FREE and will not “hang up” during routing
operations.
23. KEEP HANDS CLEAR OF CUTTER when motor is running to
prevent personal injury.
24. MAINTAIN FIRM GRIP on router when starting motor to resist
starting torque.
25. STAY ALERT and keep cutter clear of all foreign objects while motor
is running.
26. BE SURE MOTOR HAS COMPLETELY STOPPED before setting
machine down between operations.
27. SOME WOOD CONTAINS PRESERVATIVES WHICH CAN BE
TOXIC. Take extra care to prevent inhalation and skin contact when
working with these materials. Request, and follow, any safety information
available from your material supplier.
Fig. 1 shows the posts,
micrometer adjusting block
and guide rods assembled to
the top (flat) plate. At the left
of Fig. 2, the flat head screws
that secure the posts can be
seen.
The micrometer adjusting
block and guide rod posts are
mounted on the top side (side
on which A, B and C are stamped) of the top (flat) plate.
The posts are located in holes marked A, B, or C so that the guide rods
line up with the mounting holes in the base of your Porter-Cable Router.
Fig. 1
CARTON CONTENTS
OPERATION
* Porter-Cable Magic Guide
* Groove guide bar
* Other hardware
* Fulcrum pin
* Micrometer adjusting blocks and
guide rod posts