Filter
Top Products
10
STAND ASSEMBLY
1. Assemble the stand as shown in Fig. 4A, using 16
carriage bolts, flat washers and hex nuts. Do not
completely tighten the hardware at this time. Letters are
stamped on the stand brackets for ease in assembly.
A - Top front and rear brackets
B - Top side brackets
C - Bottom side brackets
D - Bottom front and rear brackets
IMPORTANT: THE TOP FRONT AND REAR
BRACKETS (A) FIG. 4A, ARE LONGER THAN THE
TOP SIDE BRACKETS (B) FIG. 4A. THE BOTTOM
FRONT AND REAR BRACKETS (D) FIG. 4A, ARE
LONGER THAN THE BOTTOM SIDE BRACKETS (C).
2. Assemble the rubber feet (E) Fig. 4A, to the bottom of
each leg (F) as shown. NOTE: Each rubber foot is
provided with holes for mounting the stand to the floor
surface if required.
SAW TO STAND
1. Turn saw table face down on a piece of cardboard to
protect the table surface. Place stand upside down onto
saw and align the four holes in the stand with the
mounting holes in the saw.
2. Place a 3/8" flat washer on a M8x1.25x40mm hex
head screw. Insert the hex head screw through the
mounting hole in the saw and the mounting hole in the
stand. Place another 3/8" flat washer on the hex head
screw and thread a M8x1.25 hex nut on the screw and
loosely tighten. Complete this process for the other
three holes.
3. Then, turn saw table face up, as shown in Fig. 4B
(Saw is shown fully assembled here).
3. Push down on top of the saw so the legs of the stand
adjust to the surface of the floor and tighten all stand
hardware and hardware which secures saw to stand.
Fig. 4A
Fig. 4B
A
B
B
C
C
D
E