Filter
Top Products
8
thread the screw into the shoe to clamp the fence
securely.
When ripping, position as shown in figure G and slide
the rip fence under the screw from either side of the
saw. Set the cross bar (10) at desired distance from
blade and tighten screw. For ripping, the cross bar
should be down and against the straight edge of the
workpiece as shown.
When circle cutting, adjust rip fence so that distance
from blade to hole in fence arm (11) is at the desired
radius and tighten screw. Place saw so that hole in
fence arm is over center of circle to be cut (drill hole
for blade or cut inward from edge of material to get
blade into position). When saw is properly positioned,
drive a small nail through hole in fence arm. Using rip
fence as a pivot arm, begin cutting circle. For circle
cutting, the cross bar should be up, as shown in
figure H.
G
H
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Cord not plugged in. • Plug tool into a working outlet.
• Circuit fuse is blown. • Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Porter Cable
service center or authorized
servicer.)
• Circuit breaker is tripped. • Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Porter
Cable service center or
authorized servicer.)
• Cord or switch is damaged. • Have cord or switch replaced
at a Porter Cable Service
Center or Authorized Servicer
For assistance with your product, visit our website at www.portercable.com for a list of service
centers, or call the Porter-Cable Customer Care Center at (888) 848-5175
90546382 PC600JS Jig Saw 12/10/08 9:11 AM Page 8