Filter
Top Products
5- ENG
D22727
ASSEMBLY
SPECIFICATIONS
OPERATION
Maximum Torque 125 ft./lbs.
Blows Per Minute @ 90 PSI 1800
Maximum Working Pressure 90 PSI
Air Inlet 1/4” NPT
Recommended Hose Size 3/8” I.D.
Air Consumption @ 90 PSI 3.5 SCFM
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for
unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings
should have 1/4” NPT thread.
Operation
Before each use:
●
Drain water from air compressor tank and
condensation from air lines. See air
compressor’s operators manual.
Disconnect the tool from
the air supply before
lubricating or changing sockets
●
Lubricate tool, see “Maintenance” section in
this manual.
Impact wrench sockets
and accessories must be
used with this tool. Do not use hand
sockets and accessories.
●
Select the required impact socket. This tool
has a 3/8" square drive, use 3/8” deep
sockets. Use 3/8” extensions only when
needed.
●
Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes
connecting easier.
IMPORTANT: The use of air filters and air line lubricators is recommended.
To use:
●
Turn air compressor on and allow air tank to fill.
●
Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI
pressure.
●
Set torque regulator, see chart, to set
the desired setting to avoid over
tightening.
IMPORTANT: These torque values can vary
depending on the size of the air
compressor and the cubic feet of air
(SCFM) the air compressor delivers.
#1 approximately 70-80 ft./lbs. Torque
#2 approximately 80-90 ft./lbs. Torque
#3 approximately 90-100 ft./lbs. Torque
#4 approximately 100-125 ft./lbs. Torque
Line up desired torque # with raised pin
Air Inlet
Trigger
Button
Torque
Regulator