Filter
Top Products
●
Place tool in forward or reverse position. Push button in on “F” side for forward or
“R” side for reverse.
●
Depress the trigger to operate tool.
●
Release trigger to stop tool.
●
Always disconnect air supply when changing sockets.
●
When job is complete, turn the air compressor off and store as described in the air
compressor operator manual.
6- ENG
D22725
MAINTENANCE
Push button all the way in on
the “F” side for Forward
position.
Push button all the way in on
the “R” side for Reverse
position.
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing uses
compressed air to power the tool. Because moisture in compressed air will rust the air
motor, you must lubricate the motor daily. An inline oiler is recommended.
To lubricate the air motor manually:
1. Disconnect the tool from the air supply
holding it so the air inlet faces up.
2. Depress the trigger and place one to two
drops of air tool oil in the air inlet
Depressing the trigger helps circulate oil in
the motor. NOTE: Use SAE #10 weight oil if
air tool oil is not available.
3. Connect the tool to an air source, cover the
exhaust end with a towel and run for a few
seconds.
Any excess oil in the
motor is immediately
expelled from the exhaust port. Always
direct exhaust port away from people or
objects.
Failure to lubricate the
tool at the air inlet will void your warranty.
Air Inlet
Trigger
Button
Torque
Regulator