Filter
Top Products
5–Fibre Channel over IP
Configuring FCIP
ISR651101-00 G 5-3
Configuring an FCIP Route Using the CLI
This section shows an example of the fciproute add command and provides
the steps to configure an FCIP route in the CLI (the GUI procedure is essentially
the same).
iSR6200 <1> (admin) #> fciproute add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Configuring FCIP Route:
-----------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
FC Port (1=FC1 2=FC2) [ ] 1
GE Port (1=GE1 2=GE2) [ ] 1
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [0.0.0.0 ] 192.168.1.227
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway IP Address [0.0.0.0 ]
Remote IP Address [0.0.0.0 ] 192.168.1.228
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768 ]
Table 5-1. FCIP Preconfiguration Information
Router Being Configured
IP Address
Subnet Mask
Gateway
VLAN ID and Priority
Peer Router (Remote)
IP Address