Filter
Top Products
Installation
Installing the iSR6250 Router
SN0051103-00 A 3-3
A
5. Connect the management workstation to the router (see page 3-9).
6. Configure the management workstation (see page 3-10).
7. Install the management application (see page 3-12).
8. Start the management application (see page 3-13).
9. Configure the router (see page 3-13).
10. Cable devices to the router (FC and iSCSI) (see page 3-14).
Pre-installation Check List
During the initial configuration process, the system prompts you to enter
information for each blade contained in the iSR6250 chassis. Use the space
provided in the following tables to record the IP addresses for each blade.
Table 3-2. Worksheet for Router Blade 1 (left) Parameters
Symbolic Name of the
iSR6250 Blade 1
Management port IP
address, subnet mask,
and gateway (if not using
DHCP)
iSCSI port 1 IP address,
subnet mask, and gateway
(GE-1)
IP address of the iSNS
server for iSCSI port 1 (if
iSNS will be enabled)
iSCSI port 2 IP address,
subnet mask, and gateway
(GE-2)
IP address of the iSNS
server for iSCSI port 2 (if
iSNS will be enabled)
iSCSI port 3 IP address,
subnet mask, and gateway
for the 10GE-3 port
IP address of the iSNS
server for iSCSI port 3 (if
iSNS will be enabled)