Filter
Top Products
10
Operation
• The throttle lock makes starting easier.
Always use it when starting the engine.
5. While firmly holding the auger as
illustrated, vigorously pull the starter rope.
6. When engine has ignited first, open the
choke (move the choke lever backward),
pull the starter rope again and the engine
will start.
• Keep the drill clear of everything
around it as they will start moving with
the engine start.
7. Pull the throttle lever slightly, and it will be
unlocked automatically.
8. Allow the engine to warm up for a couple
of minutes before starting operation.
•When re-starting immediately after
stopping engine, keep the choke open.
• If the engine won't start even after
repeated attempts, it may be overfed with
fuel. Remove and dry the spark plug, and
try to start again with the choke open.
NOTE
WARNING
NOTE
■ Installing Drill
1. Slide the ring clip and remove the lock pin
from the drill.
2. Put the drill onto the auger output shaft
and insert the lock pin. Cover it with the
ring clip.
■ Throttle Cable Adjustment
Check the throttle cable play and adjust to
.04 or .08 in. at the carburetor side.
■ Starting Engine
1. When first starting up after putting fuel into
the machine, or when re-starting after
running out of fuel, push the priming pump
until fuel runs out the overflow pipe.
2. Close the choke (push the choke lever
front ward).
3. While pulling the throttle lever, push in the
throttle lock and set the throttle lever to
the starting position.