RedMax HM20 Paint Sprayer User Manual


 
6
6. Pre-operation
Hose clamps are not completely tight.
Please tighten hose clamps prior to using.
Hose clamps are left loose to extend life of gaskets and
fittings.
Oil cap gasket before using and lubricate weekly so the
gasket will seal properly and prevent chemical leaks.
Oil check valve and maintain breather hole clear of
debris. Your failure to oil may can cause the tank to
collapse and crack due to vacuum created by pump
lubricate with "3 and 1" oil.
Before using, oil cap gasket, felt pump washer, and check
valve, and maintain breather hole clear of debris. Your failure
to oil, clean check valve, and maintain breather hole open to
allow air into the tank, can cause the tank to collapse and
crack, due to vacuum created by pump.
1. Before you remove cap, be sure there is no pressure in the
tank. in order to release pressure, invert unit upside down
and squeeze spray pistol (aim away from you). Pressure
will escape; when hissing stops, all pressure has been
released. Remove pump assembly by turning counter-
clockwise. The pump handle has two locking positions, one
turning clockwise and one counter-clockwise.
2. Remove cap.
3. A unit that has been used with herbicides should never be
used to spray insecticides, unless the sprayer has been
properly cleaned and all other chemicals neutralized.
Failure to do this could cause you to kill plants that have
been sprayed. Consult with the manufacturer of the
chemicals in use to obtain proper instructions.
4. Always oil the gasket on the cap of the unit, as well as the
check valve. This will extend the life of the seal and is
important for obtaining a proper seal with no leaks.
5. Mix solution in a separate container, following the
manufacturers’ directions.
6. Pour pre-mixed solution through strainer into tank. Reinstall
cap tightly.
IMPORTANT
WARNING
NOTE
7. Operation
Always release pressure in the pump prior to filling,
cleaning, or servicing the sprayer.
Before opening a container of pesticide or other spray
material, carefully read, understand, and follow all
instructions on the label.
Do not use flammable materials in the sprayer: they can
ignite and/or explode, causing serious injury.
Never use caustic or corrosive materials in the sprayer,
which could result in damage to the unit.
•A single pumping session or 40 full strokes provides
enough pressure to spray continuously for 10 mInutes -
enough to completely empty tank with just two pumping
sessions.
If sprayer is fitted with pressure relief valve - this valve will
release at 42 psi.
Spray pistol may be locked in the open position for
continual spraying.
HOW TO ADJUST THE NOZZLE
To adjust nozzle, tighten cap (turn clockwise) for fine
atomized spray, or loosen (turn counter-clockwise) for
coarser spray or solid stream.
RECOMMENDED APPLICATIONS FOR
"LAWN AND GARDEN" OR "AGRICULTURE" USAGE.
Herbicide : Yes
Insecticides/Pesticides : Yes
Fertilizers : Yes
Chlorine based : Yes
Diesel : Yes
Wettable Powder : No
Stains & Sealers : Yes
Oil Based : Yes
Solvent-Based : Yes
Viscous : No